IC695CRU320-EJ通用电气卡件
步骤：a.区域1：当您进入区域设置时，状态指示器D10和D14闪烁，表示区域1已准备好进行设定。将表示区域1大小的对象放置到灯光阵列的范围中。现在按下示教按钮以建立最高和最低中断光束，这定义了区域1。b。区域2：状态指示灯D11和D14在步骤a之后闪烁，这表示可以示教区域2。如步骤a所示，将一个代表区域2大小的对象放置在灯光阵列的范围内，然后按下“示教”按钮。c、 区域3：状态指示灯D12和D14在步骤b后闪烁，表示区域3可以设定。再次，将一个对象放置在灯光阵列的范围内，以表示区域3的大小，然后按下“示教”按钮。d、 区域4：状态指示灯D13和D14闪烁，表示可以设定区域4。将一个物体放在灯光阵列的范围内，以表示区域4的大小，然后按下示教按钮。状态指示器D14现在保持打开，它确认区域的所有参数都已临时存储在存储器中。6.完成示教要完成示教过程，请按住示教按钮，直到状态指示器D14熄灭（约5秒），这表示示教过程结束。
steps: a. Zone 1: When you enter the zone setup, status indicators D10 and D14 flash, which indicates that zone 1 is ready to be taught. Place an object that represents the size of zone 1 into the range of the light array. Now press the Teach button to establish the highest and lowest interrupted beams, which define zone 1. b. Zone 2: Status indicators D11 and D14 flash after step a, which indicates that zone 2 can be taught. As in step a, place an object that represents the size of zone 2 into the range of the light array and then press the Teach button. c. Zone 3: Status indicators D12 and D14 flash after step b, which indicates that zone 3 can be taught. Again, place an object into the range of the light array to represent the size of zone 3 and press the Teach button. d. Zone 4: Status indicators D13 and D14 flash, which indicates that zone 4 can be taught. Place an object into the range of the light array to represent the size of zone 4 and press the Teach button. Status indicator D14 now remains on, which acknowledges that all parameters for the zones have been stored temporarily in memory. 6. Complete teach To complete the teach process, press and hold the Teach button until status indicator D14 turns off (approximately 5 seconds), which signals the end of the teach process.
