GE ACC-5595-208 350-805595-208N 通用电气卡件
如果没有其他信息，这些DIP开关应保持在OFF位置。DIP开关8用于重置默认配置。一旦更改，DIP开关设置仅在电源循环后才能识别。表11详细说明了I/O板的DIP开关设置。有关所列功能的更多信息，请参阅出版物10000071139。45MLA控制器的设计范围至少为4米（13.1英尺）。因此，一些半透明目标可能无法阻挡足够的光线，无法被正确检测，特别是当发射器和接收器阵列放置得更近时。使用基本控制器模型，可以使用DIP开关降低发射器强度，从而更容易检测半透明对象。根据表11，通过使用DIP开关1和2的组合，可以将发射器强度设置为全功率（默认设置）、75%的全强度功率、60%或15%。可以将基本控制器配置为忽略短光束中断，例如通过检测区域的小颗粒引起的中断。可通过打开DIP开关4（并循环电源）启用双扫描模式。在该模式下，每个光束都会被求值两次（而不是一次），并且只有在两次求值期间中断的光束才会被识别。这允许忽略短暂的光束中断。响应时间增加。
If no information is otherwise provided these DIP switches should remain in the OFF position. DIP switch 8 is used to reset default configuration. Once changed, DIP switch settings are only recognized after a power cycle. Table 11 details DIP switch settings for the I/O board. See Publication 10000071139 for further information on the listed functions. The 45MLA controller is designed to work with a range of at least 4 m (13.1 ft). As a result some translucent targets may not block enough light to be properly detected, especially if the emitter and receiver arrays are placed closer together. With the Basic Controller model, it is possible to use DIP switches to decrease the emitter intensity, therefore making it easier to detect translucent objects. The emitter intensity may be set to full power (default setting), 75% of full intensity power, 60%, or 15% by using a combination of DIP switches 1 and 2 according to Table 11. It is possible to configure the Basic Controller to ignore short beam interruptions, such as those caused by small particles that pass through the detection area. The double-scan mode can be enabled by turning on DIP switch 4 (and cycling power). In this mode, every beam is evaluated twice (instead of once) and only beams that are interrupted during both evaluations are recognized. This allows brief beam interruptions to be ignored. The response time is increased.
