FOXBORO FBM232 P0926GW 自动化模块备件
注意：通过适当的接地或分流以及使用静电控制包装和材料搬运产品，帮助保护控制器免受ESD的影响。通过接地、电离和使用导电和耗散静电控制材料来耗散和中和。罗克韦尔自动化出版物45MLA-IN002C-EN-P-2020年8月5 45MLA控制器安装说明•在示教过程中随时关闭电源可取消该过程。先前存储的值仍然有效。•模拟输出在示教过程中处于激活状态，输出值表示基于电流中断光束和当前示教过程期间示教值的实际状态。•通过将DIP开关1:8设置为ON并循环电源，可以重置默认值（模拟输出缩放到连接的灯阵列的全长）。•将不同长度的光阵列对连接到控制器会导致模拟输出缩放到阵列的整个长度，从而覆盖最小和最大模拟输出值的任何设定值。•通过改变在示教过程中呈现两个不同大小对象的顺序，可以使模拟输出的斜率为正或负。例如，在步骤2中呈现较高的对象而在步骤3中呈现较短的对象会导致模拟输出中的负斜率。功能描述-基本模型图4-基本模型该控制器模型提供一个基本的离散（开/关）输出，指示阵列的整体状态。引脚列表表10显示了主连接器J2上的引脚分配。S1 DIP开关阵列上的DIP开关设置DIP开关1…6配置用于表11中所述的各种应用。
TTENTION: Help protect the controller from ESD with proper grounding or shunting and the use of static control packaging and materials handling products. Dissipate and neutralize by grounding, ionization, and the use of conductive and dissipative static control materials. Rockwell Automation Publication 45MLA-IN002C-EN-P - August 2020 5 45MLA Controller Installation Instructions • Turning off power at any time during the teach process cancels the process. The previously stored values remain valid. • The analog output is active during the teach process and the output value represents the actual state based on the current interrupted beams and the values that are taught during the current teach process. • Default values (analog output scaled to full length of connected light arrays) can be reset by setting DIP switch 1:8 to ON and cycling power. • Connecting a different length light array pair to the controller results in the analog output being scaled to the full length of the array, thus overwriting any taught values for minimum and maximum analog output value. • The slope of the analog output can be made positive or negative by changing the order in which the two different sized objects are presented during the teach process. For example, presenting the taller object in step 2 and the shorter object in step 3 results in a negative slope in the analog output. Functional Description — Basic Model Figure 4 - Basic Model This controller model provides a basic discrete (on/off) output that indicates the overall state of the arrays. Pin Listings Table 10 shows the allocation of pins on the main connector, J2. DIP Switch Settings DIP switches 1…6 on the S1 DIP switch array are configured for the various applications that are described in Table 11.
