VMIPCI-5664工控模块机器人备件
闪烁输出
SCP激活电源绿色OFF传感器未通电，输出激活，SCP激活ON传感器通电AC/DC型号标签颜色状态状态输出黄色OFF输出断电或SCP激活ON输出通电边缘橙色OFF边缘<.ON边缘>。闪烁输出SCP激活短路电源绿色关闭传感器未通电传感器通电或SCP激活短路保护功能SCPRightSight光电传感器在输出引线上提供短路保护SCP。该功能用于在输出负载对地短路时保护传感器免受损坏。如果确实出现这种情况，SCP将激活，橙色和黄色LED将闪烁对于AC/DC型号，只有橙色指示灯闪烁，直到短路源消除对于AC/直流型号，必须重置电源。
整个电压范围内
设置为00mA。典型响应曲线0 009.0 009.00009.0008.边缘感测范围感测范围毫米英寸0 00边缘曲线梁模式接线图。V AC/DC传感器直流接线用于EFC型号交流接线用于EF/C型号棕色黑色蓝色棕色蓝色电缆电缆快速断开快速断开红/白红红/黑红/白/红红黑负载负载负载L LL 0.80V DC传感器带双NPN和PNP输出的型号棕色蓝色白色黑色电缆快速断开棕色白色蓝色蓝色负载负载负载负载DC微型注：所示快速断开型号上的所有电线颜色均参考AllenBradley线组。传感器尺寸mm英寸灵敏度调整指示器。
Flash output
SCP activation power green OFF sensor is not powered on, output is active, SCP activation ON sensor is powered on AC/DC model label color status status output yellow OFF output power off or SCP activation ON output power on edge orange OFF edge< ON Edge>. Flashing output SCP activation short circuit power supply green off sensor is not powered on sensor is powered on or SCP activation short circuit protection function SCPRightSight photoelectric sensor provides short circuit protection SCP on the output lead. This function is used to protect the sensor from damage when the output load is short circuited to ground. If this does happen, SCP will activate, orange and yellow LEDs will flash for AC/DC models, only orange LEDs will flash until the short circuit source is removed For AC/DC models, the power must be reset.
Over the entire voltage range
Set to 00mA. Typical response curve 0 009.0 009.00009.008. Edge sensing range mm inch 0 00 edge curve beam mode wiring diagram. V AC/DC sensor DC wiring is used for EFC model AC wiring is used for EF/C model brown black blue blue cable cable quick disconnect red/white red red/black red/white/red red black load load L LL 0.80V DC sensor model with dual NPN and PNP output brown blue black cable quick disconnect brown white blue load load load load load DC micro note: all wire colors on the quick disconnect model refer to Test Allen Bradley line group. Sensor size mm inch sensitivity adjustment indicator.
