VMIVME-7750-734001 DCS工控模块备件
遵循以下步骤
如果需要使用信道代替遵循以下步骤：确保您的软件将永久设置为高电平这将永久禁用接收器焊接一个分流电阻器代替（焊料滴就可以了 通过收发器将总线（包括握手信号控制和命令）连接到阳连接器图 如上所述与端口共享连接到收发器连接到点连接器该设计包括用于总线终端电阻器选择的可选跳线图 显示接口带有透射式模块和触摸面板其集成驱动为显示面积为英寸对角线测量原始分辨率为 点
模块模块通过信号复位
如上所述该与端口和按钮共享芯片选择信号连接到；跳线可以断开它使得该线可用于其他定制用途通过与通信其中位并行“样”协议数据总线必须由软件实现 评估套件硬件开发板用户指南––年月日图块背光控制背光由四个平行排列的集成白色芯片组成它们由电荷泵驱动由通过单个线接口控制；欧姆电阻器串联安装在该线路上这允许将其用于其他定制用途在这种情况下上拉电阻器默认保持电荷泵永久启用在阳极驱动线上欧姆电阻器串联实现用于可选的电流限制
Follow these steps
If you need to use a channel instead, follow these steps: Make sure your software will be permanently set to high level, which will permanently disable the receiver from welding a shunt resistor instead (solder drops can be used to transfer the bus through the transceiver (including handshake signal control and command) Connect to the male connector diagram Share with the port as described above Connect to the transceiver Connect to the point connector This design includes an optional jumper diagram for bus terminal resistor selection Display interface with transmissive module and touch panel Its integrated drive is the display area is inches Diagonal measurement original resolution is points
Module reset by signal
As described above, the port and button sharing chip selection signal are connected to the; The jumper can be disconnected so that the wire can be used for other customized purposes. The "sample" protocol data bus must be implemented by software. The evaluation kit hardware development board user's guide – – The figure block backlight control backlight is composed of four integrated white chips arranged in parallel. They are driven by the charge pump and controlled by a single line interface; The ohmic resistor is installed in series on the line, which allows it to be used for other customized purposes. In this case, the pull-up resistor keeps the charge pump permanently enabled by default. The ohmic resistor is implemented in series on the anode drive line for optional current limiting
