VMIVME-7807-41100自动化模块备件
目标描述
动态制动电阻器安装数据本出版物的目的是为您提供公告动力制动电阻器的尺寸和连接图动态制动是一种可选的控制功能有助于在故障情况下或响应滑行/停止时停止电机动态制动不会提供保持制动功能仅在电机旋转时有效电阻器的尺寸适合于等于电机惯性两倍或三倍的外部惯性并且适合于从最大速度开始每小时连续三次停止驱动器必须配备常闭接触器极以便使用动态制动尺寸和连接图使用表找到正确的电枢电压额定值和套件目录号在整个表格中参考适当的尺寸和连接图
动态制动电阻器套件
电机电枢电压基本目录尺寸连接瓦数图安装说明动态制动电阻器目录号动态制动器是一种可选的控制功能有助于在故障情况下或响应滑行/停止时停止电机动态制动不会提供保持制动功能仅在电机旋转时有效电阻器的尺寸适合于等于电机惯性两倍或三倍的外部惯性并且适合于从最大速度开始每小时连续三次停止驱动器必须配备常闭接触器极以便使用动态制动注意：国家电气规范和地方规范概述了安全安装电气设备的规定安装必须符合有关导线类型导线尺寸分支电路保护和断开装置的规范
Objective Description
The purpose of this publication is to provide you with the size and connection diagram of the dynamic braking resistor. Dynamic braking is an optional control function. It helps to stop the motor in case of failure or in response to coasting/stopping. Dynamic braking does not provide the holding braking function. Only when the motor is rotating, the size of the effective resistor is suitable for the external inertia equal to two or three times the motor inertia and is suitable for the maximum speed The drive must be equipped with normally closed contactor poles at the beginning of three consecutive stops per hour in order to find the correct armature voltage rating and kit catalog number using the dynamic brake dimensions and connection diagrams Refer to the appropriate dimensions and connection diagrams throughout the table
KIT-DYNAMIC BRAKE RESISTOR
Motor armature voltage Basic catalog size Connection Wattage diagram Installation instructions Dynamic brake resistor Catalog number Dynamic brake is an optional control function Helps stop the motor in case of a fault or in response to coasting/stopping Dynamic brake does not provide a holding brake function Only when the motor is rotating The size of the effective resistor is suitable for external inertia equal to two or three times the motor inertia and is suitable for continuous operation every hour from the maximum speed The third stop drive must be equipped with normally closed contactor pole for dynamic braking Note: the national electrical code and local codes outline the provisions for safe installation of electrical equipment The installation must comply with the specifications for the protection and disconnection devices of branch circuit with respect to the type of wire
