XVC769AE101 DCS模块
型热阻组件引脚功能描述
引脚号记忆描述模拟部分.电源。将去耦电容器（每个引脚上一个和一个，导轨上一个μ）连接到尽可能靠近这些引脚的接地平面。、、、、、、、至、、、至至接地。将所有接地引脚连接到具有低热阻和电阻抗的接地平面。输入。是一个单端Ω输入，工作频率为.至，内部交流耦合。标称输入功率电平为−。.低压差（）稳压器输出。将直接连接到引脚（）。数字部分的.电源。将此电源直接连接到引脚（）。将μ电容器接地，尽可能靠近.发射机状态机前进。如果状态机被启用，脉冲使发射机状态机进入其周期中的下一状态。如果当前处于周期结束，脉冲将指针返回到（寄存器，位）中定义的模式。
变送器状态机复位
如果启用状态机，立即将传输控制状态机设置回_和_寄存器（寄存器和寄存器）中的配置。乘法器滤波器状态机前进。如果状态机被启用，脉冲使乘法器滤波器状态机前进到其周期中的下一状态。如果当前处于周期结束，脉冲将指针返回到__（寄存器，位）中定义的模式。乘法器滤波器状态机复位。如果启用状态机，立即将乘法器滤波器状态机设置回___和___寄存器（寄存器和寄存器）中定义的配置。串行时钟。引脚用于将数据输入和输出接口。串行数据输入输出。引脚是一个高阻抗数据输入，用于信息打卡。
Function description of the pin of the thermal resistance module
Pin number memory describes the analog part Power Supply. Remove the decoupling capacitors (one on each pin and one on the rail μ） Connect to the ground plane as close as possible to these pins To,,, to ground. Connect all grounding pins to the grounding plane with low thermal resistance and impedance. Enter. It is a single ended Ω input with an operating frequency of. to and internal AC coupling. The nominal input power level is − Low dropout () regulator output. Connect directly to pin (). Power supply of digital part. Connect this power supply directly to pin (). take μ The capacitor shall be grounded as close as possible The transmitter state machine advances. If the state machine is enabled, the pulse moves the transmitter state machine to the next state in its cycle. If it is currently at the end of the cycle, the pulse returns the pointer to the mode defined in (register, bit).
Transmitter state machine reset
If the state machine is enabled, immediately set the transmission control state machine back to_ And_ Configuration in registers (registers and registers). Multiplier filter state machine advances. If the state machine is enabled, the pulse advances the multiplier filter state machine to the next state in its cycle. If it is currently at the end of the cycle, the pulse returns the pointer to__ (register, bit). Multiplier filter state machine reset. If the state machine is enabled, immediately set the multiplier filter state machine back to___ And___ The configuration defined in registers (registers and registers). Serial clock. Pins are used for data input and output interfaces. Serial data input and output. The pin is a high impedance data input for information clock in.
