控制模块IS200RCSAG1
适配器
如果在此之前断电，适配器可能会永久损坏。以这种方式损坏的适配器无法修理。自动化出版物20COME-RN003A-EN-P-2012年5月20-COMM-E EtherNet/IP适配器固件版本4.002 5安装闪存套件1.访问Allen Bradley网站更新：http://www.ab.com/support/abdrives/webupdate并为20-COMM-E适配器安装闪存套件。（这也会自动在您的计算机上安装ControlFLASH软件。）2.您现在可以使用DriveExplorer、DriveExecutive、ControlFLASH或HyperTerminal来更新适配器。请参阅下面的相应章节并按照说明进行操作。
使用
1.安装了Flash Kit（请参阅安装闪存套件）后，启动DriveExplorer并使用连接到适配器的驱动器联机（仅使用DriveExplorer Full或1203-USB或1203-SSS转换器通过EtherNet/IP）。2.在DriveExplorer树视图中，单击20-COMM-E适配器。然后单击第3页图1所示的信息图标以显示适配器的Properties屏幕。3.在20-COMM-E属性屏幕上，单击详细信息选项卡。4.要启动闪存更新，请单击闪存更新…按钮。然后从可用更新列表中选择“4.002.xx完整”，然后单击下一步>。按照其余屏幕提示操作，直到闪存更新过程完成并显示新固件版本（v4.002）。
Adapter
If power is lost before this, the adapter may be permanently damaged. An adapter that is damaged in this way cannot be repaired. Automation Publication20COME-RN003A-EN-P-2012 May 20-COMM-E EtherNet/IP Adapter Firmware Version 4.002 5 Install Flash Kit 1. Visit the Allen Bradley website for updates: http://www.ab.com/support/abdrives/webupdate Install the flash kit for the 20-COMM-E adapter. (This will also automatically install ControlFLASH software on your computer.) 2. You can now use DriveExplorer, DriveExecutive, ControlFLASH or HyperTerminal to update the adapter. Refer to the appropriate sections below and follow the instructions.
use
1. After installing the Flash Kit (see Installing the Flash Kit), start DriveExplorer and use the drive connected to the adapter to go online (only use DriveExplorer Full or 1203-USB or 1203-SSS converters to pass EtherNet/IP). 2. In the DriveExplorer tree view, click 20-COMM-E adapter. Then click the information icon shown in Figure 1 on page 3 to display the Properties screen of the adapter. 3. On the 20-COMM-E Properties screen, click the Details tab. 4. To start the flash update, click the Flash Update... button. Then select 4.002.xx Complete from the list of available updates, and click Next>. Follow the remaining screen prompts until the flash update process is complete and the new firmware version (v4.002) is displayed.
