ABB 07XS01 GJR2280700R3工控DCS系统备件
横向±3°设置高度：
海拔2000m以下振动：0m/s2震动：0m/s安装条件：简单面板安装（下方和左右两侧应留有空间）风：无外部噪音：无预热时间：30分钟或更长■ 正常工作条件环境温度：-10°C至50°C（封闭安装时为-10°C到40°C）环境湿度：10至90%RH（无冷凝）电源电压：一般电源规格90至264VAC 24V电源规格21.6-26.4VDC/AC电源频率：一般电源规范50/60Hz±2%24V电源规范DC，50/60Hz±2%安装方向：向前或向后±10°，横向±10°设置高度：海拔2000m以下振动：2 m/s2冲击：0m/s2安装条件：简单面板安装（上下应有空间）外部噪音：无环境温度变化率：小于10°C/小时
设置数据
执行上述故障排除后，如果问题没有得到改善，请联系经销商或当地CHINO的销售代理。警告当需要维修或修改本仪器时，请联系经销商或当地CHINO的销售代理。确保除CHINO CORPORATION批准的维修工程师外，任何人不得通过更换零件来维修或修改本仪器。由于意外故障（停电、地震或其他意外事故），在维修过程中可能会删除设置数据。在维修仪器之前备份设置数据。我们不对丢失或损坏的数据负责
Lateral ± 3 ° Setting height:
Vibration below 2000m above sea level: 0m/s2 Vibration: 0m/s Installation conditions: simple panel installation (space should be left at the bottom and left and right sides) Wind: no external noise: no preheating time: 30 minutes or more ■ Normal working conditions Ambient temperature: - 10 ° C to 50 ° C (- 10 ° C to 40 ° C when closed installation) Ambient humidity: 10 to 90% RH (non condensing) Power voltage: general power specification 90 to 264VAC 24V power specification 21.6-26.4VDC/AC power frequency: general power specification 50/60Hz ± 2% 24V power specification DC, 50/60Hz ± 2% Installation direction: forward or backward ± 10 °, transverse ± 10 ° Setting height: altitude below 2000m Vibration: 2 m/s2 Impact: 0m/s2 Installation condition: simple panel installation (there should be space above and below) External noise: no ambient temperature change rate: less than 10 ° C/hour
Set Data
After the above troubleshooting, if the problem is not improved, please contact the dealer or the local CHINO sales agent. Warning When the instrument needs to be repaired or modified, please contact the dealer or the local CHINO sales agent. Ensure that no one except the maintenance engineer approved by CHINO CORPORATION can repair or modify the instrument by replacing parts. Due to unexpected failures (power failure, earthquake or other accidents), the setting data may be deleted during maintenance. Back up setup data before servicing the instrument. We are not responsible for lost or damaged data
