3BSE004772R1工控自动化卡件
SV编号
① 当选择数字输出规范或通信规范和通信协议“Modbus”时，将显示该信息。② 为设置的每个模式/步骤设置SV编号。③ 它从数字1设置为8。也可以设置数字0。在这种情况下，函数以与上一步相同的编号继续。5.时间信号号① 仅显示具有外部信号输出（DO）的规格。② 对于设置的每个模式/步骤，设置要使用的时间信号输出目的地和时间信号编号。③ 将时间信号输出目的地设置为“TS”，将时间信号编号设置为“No.”。④ 将时间信号编号从1号设置为8号，编号为1R-8R，打开和关闭。编号后的“R”用于重复时间信号，仅在该步骤中，该编号的时间信号以相同的设置值重复“开”表示一切打开，“关”表示一切关闭。
SV范围
① 设置SV设置范围。② 设置范围在输出信号范围内。③ 当SV小数点、SV标度等有时自动相对改变时，设置范围和小数点位置可能会改变或发生初始化，因此要小心。7.图案重复① 设置模式重复（重复）。② 这是一个非常方便的功能，如果你想重复相同模式号的程序模式。③ 当设置“0001”时，相同的模式重复一次。因此，总的来说，相同的模式会运行两次。”“模式重复”不仅适用于执行模式，而且该设置值始终处于启用状态，因此请小心。
SV No
① This message is displayed when the digital output specification or communication specification and communication protocol "Modbus" are selected. ② Set SV number for each mode/step set. ③ It is set from the number 1 to 8. You can also set the number 0. In this case, the function continues with the same number as in the previous step. 5. The time signal number ① only displays specifications with external signal output (DO). ② For each mode/step set, set the time signal output destination and time signal number to be used. ③ Set the time signal output destination to "TS" and the time signal number to "No.". ④ Set the time signal number from No. 1 to No. 8, numbered 1R-8R, open and close. The "R" after the number is used to repeat the time signal. Only in this step, the time signal with the number repeats "ON" with the same setting value, indicating that everything is turned on, and "OFF" indicates that everything is turned off.
SV Range
① Set SV setting range. ② The setting range is within the output signal range. ③ When SV decimal point, SV scale, etc. are sometimes automatically and relatively changed, the setting range and decimal point position may change or be initialized, so be careful. 7. Pattern repetition ① Setting mode repetition (repetition). ② This is a very convenient function, if you want to repeat the program mode with the same mode number. ③ When "0001" is set, the same mode is repeated once. Therefore, in general, the same mode will run twice. " Repeat Mode is not only applicable to the execution mode, but also the setting value is always on, so be careful.
