DSRF182 PLC模拟量输出模块
开箱和检查
1.立即检查五金件，确认其在运输过程中没有损坏。2.将任何此类损坏通知最近的Elsag Bailey销售办事处。3.向处理货物的运输公司提出任何损坏索赔。4.使用原包装材料和容器存放五金件。5.将五金件存放在空气质量良好、无极端温度和湿度的环境中。设置/物理安装安装前，设置模块S1地址开关并安装跳线以配置数字输入。配置终端单元（TU）或终端模块（TM）以接受现场设备信号
控制模块的I/O模块
地址选择开关（S1）DSI可以在I/O扩展器总线上具有64个地址（地址0至63）中的一个。该地址唯一标识控制模块的I/O模块，并且必须与控制模块配置中设置的地址相同（功能代码84规范S1）。地址由八位地址双列直插式开关（S1）设置。S1的六个右开关位置（3至8）设置六位DSI地址。位置1和2不使用，必须保持在关闭位置 。 是用于设置S1的二进制地址转换表。数字输入跳线设置IMDSI13和IMDSI14模块具有固定配置，因此不需要跳线设置。IMDSI12（24/48/125 VDC或120 VAC）模块要求跳线设置工作电压和直流或交流模式选择。IMDSI15（125 VDC/120 VAC）模块需要直流或交流模式选择跳线设置。
Unpacking and inspection
1. Check the hardware immediately to make sure it is not damaged during transportation. 2. Notify the nearest Elsag Bailey sales office of any such damage. 3. Make any claim for damage to the transportation company handling the goods. 4. Use the original packaging materials and containers to store the hardware. 5. Store the hardware in an environment with good air quality and without extreme temperature and humidity. Before setup/physical installation, set the module S1 address switch and install jumpers to configure digital inputs. Configure the Terminal Unit (TU) or Terminal Module (TM) to receive field device signals
I/O module of control module
The address selector switch (S1) DSI can have one of 64 addresses (addresses 0 to 63) on the I/O expander bus. This address uniquely identifies the I/O module of the control module and must be the same as the address set in the control module configuration (functional code 84 specification S1). The address is set by the 8-bit address dipswitch (S1). The six right switch positions (3 to 8) of S1 set the six digit DSI address. Positions 1 and 2 are not used and must remain in the closed position. Is the binary address translation table used to set S1. Digital input jumper settings IMDSI13 and IMDSI14 modules have a fixed configuration, so jumper settings are not required. IMDSI12 (24/48/125 VDC or 120 VAC) modules require jumpers to set the operating voltage and DC or AC mode selection. The IMDSI15 (125 VDC/120 VAC) module requires DC or AC mode selection jumper settings.
