PM510V16控制处理器
标准功能和选项
标准KCR 760电压调节器提供的功能，选件
本系列可供选择，可提供各种附件
发电机组的电压调节系统在以下段落。哪些选项是特定的 在采购订单中，在工厂调节器内进行所需的电路更改而附件是安装在调节器外部的部件。
标准传感：基本KCR 760调节器使用单相50/60Hz感测。传感变压器具有多抽头一次允许
在100至600 Vac的感测电压下操作。标准调节器包括降低中电压的欠频限制电路
当速度下降到UFL以下时，频率下降的比例操作阈值。标准50/60 Hz传感调节器中的UFL
对于50 Hz的应用，使用48 Hz的操作阈值进行调整对于60Hz的应用为58Hz。
可选传感：当规格 ed：在采购订单中，监管机构可以在感测电路中提供以下变化：-三相50/60 Hz，100至600 Vac感应。
-UFL设置为49.5/59.5 Hz，用于涡轮增压发动机。
-每赫兹电压电路代替UFL，用于以下应用：
在以下速度范围内，电压必须与频率成比例：
额定转速降至约1/2额定转速。
-400 Hz，单相或三相，100至600 Vac，带385 Hz UFL操作阈值。
-具有高于或低于385Hz的UFL阈值的400Hz。
-50/60 Hz或400 Hz，单相或三相100至600 Vac，带 在电动发电机组或变频/恒频调节
电压应用。监管机构 at法规将不包括：UFL或V/Hz电路。
标准输入功率和直流输出
标准KCR 760稳压器
使用单相120 Vac±10%输入功率，具有额定最大值
连续输出65VDC，10A；90 Vdc，15 A一分钟 埃尔德强迫。
可选输入功率和直流输出：当规格 购买中的ed订购时，KCR 760调节器可为modi 教育署将从单一相，240 Vac±10%输入功率，因此具有额定最大值连续输出125 Vdc，10 A；180 Vdc，15 A一分钟 埃尔德强迫。领域 灰化：KCR 760电压调节器包括固态 埃尔德 灰化电路。
标准保险丝：标准KCR 760稳压器配有15 a
稳压器内输入电源电路中的正常熔断保险丝。这保险丝提供电压调节器过载保护。
可选保险丝：在系统不包括 埃尔德
断路器和发电机 需要eld保护，较小的保险丝可以使用。发电机 eld保护，保险丝电流强度应为1
是励磁机的一半到两倍 连接额定负载时的eld电流
至发电机。保险丝电流强度不得超过15 A或三分之二开路电路强制。
Standard features and options Features provided in standard KCR 760 voltage regulators, options available in this series, and various accessories that can be supplied with the generator set voltage regulating system are described in the paragraphs that follow. Where options are speci ed in the purchase order, the required circuitry changes are made within the regulator at the factory while accessories are parts that mount external to the regulator. Standard sensing: The basic KCR 760 regulator uses single phase 50/60 Hz sensing. The sensing transformer has a multi-tap primary permitting operation at sensing voltages of 100 to 600 Vac. The standard regulator includes an underfrequency limit circuit that decreases voltage in proportion to the decrease in frequency when speed drops below the UFL operational threshold. The UFL in standard 50/60 Hz sensing regulators is adjusted with an operational threshold of 48 Hz for a 50 Hz application and 58 Hz for a 60 Hz application. Optional sensing: When speci ed in the purchase order the regulator can be supplied with the following variations in sensing circuitry: - Three phase 50/60 Hz, 100 to 600 Vac sensing. - UFL set 49.5/59.5 Hz for use with turbocharged engines. - Volts-per-hertz circuitry in place of UFL for applications where voltage must be proportional to frequency over a speed range from rated rpm down to approximately 1/2 rated speed. - 400 Hz, single or three-phase, 100 to 600 Vac with 385 Hz UFL operational threshold. - 400 Hz with UFL threshold higher or lower than 385 Hz. - 50/60 Hz or 400 Hz, single or three-phase 100 to 600 Vac with at regulation for a motor-generator set or variable frequency/constant voltage applications. Regulators with at regulation will not include UFL or V/Hz circuitry. Standard input power and dc output: Standard KCR 760 regulator uses single-phase, 120 Vac ±10% input power and has rated maximum continuous output of 65 Vdc, 10 A; 90 Vdc, 15 A one-minute eld forcing. Optional input power and dc output: When speci ed in the purchase order, the KCR 760 regulator may be modi ed to operate from single phase, 240 Vac ±10% input power and thereby have rated maximum continuous output of 125 Vdc, 10 A; 180 Vdc, 15 A one-minute eld forcing.
