3BHL000391P0101可控硅IGCT模块
在将新终端放入之前，请仔细阅读这些说明活动
插入端子前，确保端子上的电压标签与本地电源电压匹配。如果不是这样，不要在任何情况下连接终端。
尽管IND780结构坚固，但它仍然是精确的仪器在搬运和安装术语“操作环境”时要小心
选择位置时：•选择稳定、无振动的表面•确保温度无过度波动，且无直接影响阳光照射
•避免气流（例如，风扇或空调）
•地理位置发生任何重大变化后，重新调整（校准）终端位置
温湿度IND780可在以下温度和相对湿度条件下运行：在HTtable 1-1的操作环境下列出。终端可存储在
温度范围为-40°至60°C（-40°至140°F），相对湿度，不冷凝。
环境保护严苛外壳符合IP69K要求
。面板安装前面板密封提供与IP65等级相当的4型和12型保护。危险区域
并非所有版本的IND780都可在危险区域运行根据国家电气规范（NEC），由于易燃或易爆这些地区的大气。联系授权梅特勒·托莱多危险应用信息代表。安全处置要求符合关于废物的欧洲指令2002/96/EC
电气和电子设备（WEEE）：本设备可能不在生活垃圾中处理。这也适用于外部国家欧盟，根据其具体要求。请按照当地法规处置本产品，网址为：为电气和电子设备指定的收集点。
如果您有任何问题，请联系负责部门或您购买此设备的分销商。
该设备是否应传递给其他方（私人或专业使用），本法规的内容也必须相关。
感谢您对环境保护的贡献。
Please read these instructions carefully before putting the new terminal into
operation.
Before plugging in the terminal, make sure that the voltage stated on the terminal's
label matches the local power supply voltage. If this is not the case, do not
connect the terminal under any circumstances.
Although the IND780 is ruggedly constructed, it is nevertheless a precision
instrument. Use care in handling and installing the term Operating Environment
When selecting a location:
• Choose a stable, vibration-free surface
• Ensure there are no excessive fluctuations in temperature and no direct
exposure to sunlight
• Avoid drafts (for example, from fans or air conditioning)
• Readjust (calibrate) the terminal after any major change of geographical
position
Temperature and Humidity
The IND780 can be operated at temperatures and relative humidity conditions as
listed under Operating Environment in HTable 1-1. The terminal can be stored at
temperatures ranging from –40° to 60° C (–40° to 140° F) at 10 to 95% relative
humidity, non-condensing.
Environmental Protection
The harsh enclosure meets IP69K requirements. The Panel Mount front panel
sealing provides type 4 and type 12 protection—comparable to IP65 rating.
Hazardous Areas
Not all versions of the IND780 can be operated in areas classified as Hazardous
by the National Electrical Code (NEC) because of the combustible or explosive
atmospheres in those areas. Contact an authorized METTLER TOLEDO
representative for information about hazardous applications. Safe Disposal Requirement
In conformance with the European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE) this device may not be
disposed of in domestic waste. This also applies to countries outside
the EU, per their specific requirements.
Please dispose of this product in accordance with local regulations at
the collecting point specified for electrical and electronic equipment.
If you have any questions, please contact the responsible authority or
the distributor from which you purchased this device.
Should this device be passed on to other parties (for private or
professional use), the content of this regulation must also be related.
Thank you for your contribution to environmental protection.
