DSQC604机器人模块,DSQC604中文PDF使用手册
机器故障计时器超时。
状态LED/红色和输出显示LED/on。重置IMHSS03。
1.转动面板上的指旋螺钉½-转动以解锁模块。
2.拉动模块面板，直到模块与MMU背板连接器断开连接。
3.推动模块面板，重新放置模块直到模块与MMU背板连接。
4.转动面板指旋螺钉½-圈，直到模块锁定到位。
重置模块和机器故障计时器超时继续。
DSQC604机器人模块状态LED/红色和输出显示LED/on。更换IMHSS03。
1.转动面板上的指旋螺钉½-转动以解锁模块。
2.拉动模块面板，将模块从MMU。参考第3节和第4节安装和校准更换模块。断电。所有LED熄灭。1、取下IMHSS03，检查系统电源。有关详细信息，请参阅相应的电力系统说明故障排除程序。断电和系统功率检查良好。所有LED熄灭。更换IMHSS03。
1.转动面板上的指旋螺钉½-转动以解锁模块。
2.拉动模块面板，将模块从MMU。参考第3节和第4节安装和校准更换模块。Machine fault timer
time-out.
Status LED/red and
OUT DIS LED/on.
Reset IMHSS03.
1. Turn the thumbscrews on the faceplate ½-turn to unlock
the module.
2. Pull on the module faceplate until the module discon
nects from the MMU backplane connector.
3. Reseat the module by pushing on the module faceplate
until the module connects with the MMU backplane connec
tor.
4. Turn the faceplate thumbscrews ½-turn until the module
locks in place.
Reset module and
machine fault timer
time-out continues.
Status LED/red and
OUT DIS LED/on.
Replace IMHSS03.
1. Turn the thumbscrews on the faceplate ½-turn to unlock
the module.
2. Pull on the module faceplate, remove the module from
the MMU.
3. Refer to Sections 3 and 4 to install and calibrate the
replacement module.
Loss of power. All LEDs off. 1. Remove IMHSS03 and check the system power.
2. Refer to the appropriate power system instruction for
troubleshooting procedures.
Loss of power and
system power
checks good.
All LEDs off. Replace IMHSS03.
1. Turn the thumbscrews on the faceplate ½-turn to unlock
the module.
2. Pull on the module faceplate, remove the module from
the MMU.
3. Refer to Sections 3 and 4 to install and calibrate the
replacement module.
