KCEU14201F51PEB模块,KCEU14201F51PEB使用产品
HSS模块上有31个跳线。这些跳线
选择选项，如伺服阀或I/H转换器模式，四I/H转换器模式、伺服阀输出电流和交流或直流LVDT中的应急错误定位为20毫安变压器。表3-6列出了HSS模块跳线设置。
图3-2显示了跳线的详细信息。图3-1显示了J31在高速钢电路板上的位置。将跳线设置为满足特定系统的要求。要在模块安装单元中安装HSS模块：1.定位模块安装单元插槽分配单元
KCEU14201F51PEB模块2.检查模块安装单元背面的输入/输出扩展总线分流器插座。双极分流器必须安装时所有针脚均短路。从MFP模块到输入/输出模块必须有通信路径。
3、将电路卡的上边缘和下边缘与模块安装单元中指定插槽的顶部和底部导轨。4、将模块滑入插槽。推动直到模块位于背板连接器中。转动2个指旋螺钉在面板上旋转½圈，直到模块锁定到位。here are 31 jumpers on the HSS module. These jumpers
select options such as servo valve or I/H converter mode, four
to 20 milliamp positioning for contingency errors in I/H converter mode, servo valve output current, and AC or DC LVDT
transformers. Table 3-6 lists the HSS module jumper settings.
Figure 3-2 shows details of the jumpers. Figure 3-1 shows the
location of J31 on the HSS circuit board. Set the jumpers to
meet the requirements of your particular system.To install the HSS module in the module mounting unit:
1. Locate the module mounting unit slot assignment for the
module.
2. Check the I/O expander bus dipshunt socket on the backplane of the module mounting unit. The dipshunt must be
installed with all pins shorted. There must be a communication path from the MFP module to the I/O module.
3. Align the top and bottom edges of the circuit card with the
top and bottom rails of the assigned slot in the module mounting unit.
4. Slide the module into the slot. Push until the module is
seated in the backplane connector. Turn the 2 thumbscrews
on the faceplate ½-turn until the module locks in place.
