CI830开关量模块,CI830怎么使用
安装称重传感器将轴承安装在称重传感器中。
注意事项使用不会损坏轴承或称重传感器的工具和材料。
注意事项其中一个轴承用挡圈锁定到位其他轴承仅压入正确位置，以允许轴向膨胀。
a、 将一个挡圈安装到称重传感器中。
b、 如下图所示，布置一个埋头台。
c、 将轴承压到正确位置。
注意事项轴承座只有轻微的过盈配合，因此没有较大的力应使用。
CI830开关量模块d、 将另一个挡圈安装到称重传感器中。将轴承的挡圈安装到轴上。将外盖放置到位。
定位测量辊，连同称重传感器在机器上的正确位置。
轴承松动的称重传感器朝着轧辊移动，为了减少总长度，使测量辊与可以安装称重传感器。
当辊子就位时，用将轴承松动回其正确位置。
使用四个安装螺钉固定每个称重传感器。（拧紧力矩根据制造商的建议）
如有必要，调整轴密封件
Mounting the Load Cells
1. Mount the bearings in the load cells.
NOTE
Use tools and materials that not will damage the bearing or the load cell.
NOTE
One of the bearings is locked in position with retaining rings while the
other bearing is only pressed into the correct position to allow axial expansion.
a. Mount one of the retaining rings into the load cell.
b. Arrange a counterstay as shown in the figure below.
c. Press the bearing to correct position.
NOTE
The bearing bed has only a slight interference fit, and, therefore, no heavy forces
should be used.
d. Mount the other retaining ring into the load cell. Mount the retaining rings for the bearings on the shaft.
Put the outer lids in position.
6. Position the measuring roll complete with the load cells
into the correct position on the machine.
The load cell with the loose bearing is displaced towards the roll,
in order to reduce the total length, so that the measuring roll with
the load cells can be fitted in.
When the roll is in position pull the load cell with the
loose bearing back to its proper position.
7. Fix each load cell by using the four mounting screws.
(tightening torque according to the manufacturer´s recommendations)
8. Adjust the shaft sealings, if necessary
