UNITROL 1010励磁模块,ABB使用尺寸UNITROL 1010
完整的设置由许多主菜单和子菜单组成。下表显示了逐步完成完整设置时按外观顺序排列的主菜单。
概述了您可以在以下每个主菜单中执行的选择和参数设置。
第3.12.3节“设置腹板宽度”描述了完整的设置顺序仅当所选单位为N/m、kN/m、kg/m或物价指数。
默认腹板宽度为2m（78740英寸）。
UNITROL 1010励磁模块格式为XX。XXX如果宽度输入米和XXXX。XX如果输入了宽度英寸最大腹板宽度为50m（1968,5英寸）
3.12.1.4设置小数
可在此菜单中设置显示的小数位数。可以设置小数位数至0-5之间的数字，具体取决于称重传感器的标称荷载和表示单位。
第4.6节进一步解释了集合小数函数。为了能够在显示屏上显示实际腹板张力，腹板张力与必须确定称重传感器上测得的力。
该比率是一个称为包裹增益的比例因子。
包裹增益取决于卷筒在测量辊上的包裹角度和称重传感器。因此，包裹增益取决于实际安装。
这将提供：T（张力）=缠绕增益FR（称重传感器测量方向上的腹板张力力）
The complete setup is built up by a number of main and sub menus. The table below shows the
main menus in order of appearance when stepping through the complete setup. The table also
gives an overview of the selections and parameter settings you can do below in each main menu.
The complete setup sequence is described in Section 3.12.3 Set Web Width
The menu SetWebWidth will only be available when the selected unit is N/m, kN/m, kg/m or
pli.
Default Web Width is 2m (78,740 inch).
The format is XX.XXX if the width is entered in meter and XXXX.XX if the width is entered in
inch. Maximum Web Width is 50m (1968,5 inch)
3.12.1.4 Set Decimals
The number of displayed decimals can be set in this menu. The number of decimals may be set
to a number between 0 - 5 depending on the load cell nominal load and presentation unit.
Set decimals function is further explained in Section 4.6.To be able to present actual web tension on the display, the ratio between web tension and
measured force on the load cell must be determined.
This ratio is a scaling factor called Wrap Gain.
The Wrap Gain depends on the web's wrap angle on the measuring roll and the orientation of the
load cells. Therefore, Wrap Gain depends on the actual installation.
This gives:
T (tension) = Wrap Gain FR (force of web tension in load cell measuring direction)
