RELIANCE E243伺服电机
1.产 品 详 情 资 料：
注意：RELIANCE E243端口仅用于传输应用程序数据。它不用于永久连接。在正常操作过程中，请勿让RDSD设备处于连接状态。12在出版时，RSTi EP CPE100不支持。13 Proficy公司™ OPC UA服务器配置需要RELIANCE E2430 SIM 2或更高版本。14发布时RX3i CPE400和RSTi EP CPE100的挂起。注意：使用RELIANCE E243时，所有编程软件连接必须处于脱机状态，RDSD才能正常工作。注意RELIANCE E243不支持Cfast存储卡作为RDSD设备。2.1.8.1将一个项目从CPU上传到RDSD注意事项：一次只能将一个应用程序项目存储到RDSD。在RELIANCE E243将项目写入RDSD之前，删除任何以前的应用程序；如果在上传开始时RDSD上存在名为PACS_Folder的目录，则会删除该目录及其所有内容。闪存设备写入整个存储器块，并且存储器块大小因设备而异。由于最小块大小的差异以及项目使用的块的数量的差异，项目使用的空间量可能在RDSD之间有所不同。所需的最小内存量是整个项目的大小加上options.txt文件的额外块（如果使用的话）RELIANCE E243
Note: The USB port is for transfer of application data only. It is not intended for permanent connection. Do not leave RDSD devices connected during normal operation. 12 Not supported by RSTi-EP CPE100 at the time of publication. 13 Proficy™ Machine Edition Logic Developer PLC 9.00 SIM 10, or 9.50 SIM 2, or later is required for OPC UA Server configuration. 14 Pending for RX3i CPE400 and RSTi-EP CPE100 at the time of publication.Note: When using RDSD, all programming software connections must be in the Offline state for the RDSD to function properly. Note: CPE330 does not support Cfast memory cards as RDSD devices. 2.1.8.1 Uploading a Project from the CPU to the RDSD Notes: Only one application project can be stored to the RDSD at a time. Before the RX3i writes the project to the RDSD, any previous application is removed; if a directory named PACS_Folder exists on the RDSD at the start of the upload, it is deleted with all of its contents. Flash devices write in whole memory blocks and memory block sizes vary among devices. The amount of space used by a project may vary between RDSDs due to the differences in minimum block sizes and therefore the number of blocks used by a project. The minimum amount of memory required will be the size of the entire project plus an additional block for the options.txt file, if used
2.产 品 展 示
3. 主 营 产 品
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
