KOLLMORGEN E33NRHA-LNN-NS-00电机,E33NRHA-LNN-NS-00使用方法
输入具有二阶低通硬件滤波器和数字滤波器单个时间常数为0.5至32 ms。
除了车载输入/输出，直接输入/输出系统支持S200输入/输出。最多八个外部输入/输出单元可以直接插入安装在控制器上DIN导轨和其他八个输入/输出单元可以通过TK210电缆连接（长度0.5、1.0、，或2.5 m）和200-AIO适配器。一排输入/输出单元可以使用200-CE1或200-CE3电缆，0.3和0.9米分别（不能与2.5米TK210电缆）。请注意，TK210电缆根据UL1604，危险位置不允许超过0.9 m。
远程输入/输出–PROFIBUS-DPCI274板是PROFIBUS-DP现场总线，用于远程连接S800输入/输出、S800L输入/输出、，S200输入/输出、S20KOLLMORGEN E33NRHA-LNN-NS-00电机0L输入/输出和第三方装置最大长度为100至1200 m，取决于波特率。
S800输入/输出单元连接到一个或多个输入/输出适配器，CI830。其他单位可以是通过光纤连接到CI830适配器电缆和光纤接口单元，TB820。
S200输入/输出单元连接到一个或多个输入/输出适配器，200-APB12，最大每个适配器有八个输入/输出单元。CI274板充当总线主控和处理从/到的循环读取和写入奴隶。周期时间取决于波特率速率和连接的从属服务器数。
最多可以使用两个这样的板安装在AC 800C中。车载通信信道AC 800C有两个车载RJ-45插孔，用于RS-232通道，一个带全调制解调器
The inputs have a second-order, low-pass hardware filter and a digital filter with individual time constants 0.5 to 32 ms. In addition to the on-board I/O, the direct I/O system supports S200 I/O. Up to eight external I/O units can be directly plugged onto the controller and installed on the same DIN rail, and another eight I/O units can be connected via a TK210 cable (length 0.5, 1.0, or 2.5 m) and a 200-AIO adapter. A row of I/O units can be split in two by using a 200- CE1 or a 200-CE3 cable, 0.3 and 0.9 m respectively (cannot be combined with the 2.5 m TK210 cable). Note that a TK210 cable longer than 0.9 m is not allowed in hazardous locations according to UL1604. Remote I/O – PROFIBUS-DP The CI274 board is an optional interface for the PROFIBUS-DP field bus and used for remote connection of S800 I/O, S800L I/O, S200 I/O, S200L I/O and third-party units over a maximum length of 100 to 1200 m, depending on baud rate. S800 I/O units are connected to one or more I/O adapters, CI830. Additional units can be connected to the CI830 adapter via optical cables and optical interface units, TB820. S200 I/O units are connected to one or more I/O adapters, 200-APB12, with a maximum of eight I/O units per adapter. The CI274 board serves as bus master and handles cyclic reads and writes from/to the slaves. The cycle time depends on the baud rate and the number of slaves attached. A maximum of two such boards can be installed in AC 800C. On-board communication channels AC 800C has two on-board RJ-45 jacks for RS-232 channels, one with full modem
